一. 循环水, 1个月至少换一次,换水是把水泵中的过滤海绵也拿出来清洗一次.
A circulating water, 1 months at least once, change the water is to filter sponge in water pump also take out for cleaning time
Two. Track oiling, once at least 1 months of oil, oil before the first aisle clean
Three. Honeycomb board below, regular cleaning to prevent pieces of cloth, after the cause of the fire
Four. Freezing weather, pay attention to the laser tube water may freeze, causes the laser tube rupture, Gu, in freezing weather, when not working, or to the laser tube water release, or the pump 24 hours a day, keep the water 24 hours, so it does not freeze
Five. Scrubbing lenses, 1 weeks is swabbed, if can not wipe clean, but each week to check again. Scrubbing lenses are 3 copper screws do not move the mirror behind, and the focusing mirror can not be anti loaded, the final is concave downward, concave to spot, if installed anti is astigmatism, cut out the lines very coarse, and don't know
Six. Safety, child and non operating personnel are not allowed to touch the machine, in order to prevent the outside, the line between the 2 reflector and 3 reflector is light, do not touch this area is in work, the thunderstorm days machine better off, cut off the power supply
Seven. If the machine is your factory or workshop during the festival long time holiday, do not run. Attention must be paid to the winter heat preservation office machine
Science. It must be cold water machine, water, laser cutting head, lens, the water drain off, to prevent freezing caused damage to the machine.
Drain valve open cold water machine, all the water out. Will filter out drainage, because this part of the water is not drained to prevent freezing will
The shell burst. The compressed air blowing need some difficult to discharge water, in order to prevent the water poured into the cavity, the laser damage
Department of precision sensor. Be sure to close all the water valve.
1 close all valves cold water machine.
2 open the drain valve. The water tank water drain off.
3 open all water-cooled machine filter, will be unable to drain the water out.
Joint 4 deionized bucket opened, gas will be unable to drain the water in the barrel to blow out. High pressure gas should not, under the control of the pressure
5 for the high-pressure pump internal water discharge. Open the exhaust valve, gas blowing. The water will flow to the drainage hole outflow. Here the water is not discharged if
Will pump up bad, high surface burst.
After the above 6 steps, all joint installation reduction. Although it has been done above, still can not let down. Temperature
贵州快3走势Through the low will continue cooling loop, compressor, radiator, heat exchanger, frozen. Keep the environment temperature at 5 ℃, can effectively protect the machine.